AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Itrace mouse5/1/2023 The RETERO mouse allows you to quickly switch between 3 sensitivity levels during use (800 DPI/1200 DPI/1600 DPI), which makes the device perfectly prepared for every task.Ĭheck out the color combinations offered by the RGB rainbow backlight. The optical PixArt 3065 sensor is responsible for accurate and operation with a sensitivity of up to 1600 DPI. The Tracer RATERO mouse has a smart, ergonomic design, which means it provides optimal support for the hand during long use. The symmetrical profiling of the mouse ensures comfortable work for both left and right-handed users. Ergonomic shell, minimalist design with RGB backlight, made of high-quality materials with attention to the smallest detail, five keys and the Pixart 3065 sensor make this mouse a unique tool that perfectly blends with any interior. It offers reliable 2.4 GHz wireless connectivity without interference or lag. Meet the Tracer RATERO wireless mouse designed for the special tasks you do every day. IRISC Trace Viewer (Mellanox ConnectX), mft 4.1.0-26, built on Aug 16 2015, 17:32:24.An office mouse doesn't have to be ordinary. Itrace: read memory (174712 bytes), each dot denotes 2048 bytes: This option is useful for debugging itrace it dumps the contents of the trace buffer in row format. By default, animation is enabled.ĭumps the trace buffer and exits. Sets the itrace not to animate the propeller in wait mode (-w option). Use memory mapping to access trace buffer. If the cr-space device specified by the -d parameter is one of the I2C devices, -nomap is switched on. By default, itrace accesses the memory directly. Sets the itrace to not access memory directly (via memory mapping) for reading the trace buffer, but to use the adapter memory access Gateway instead. To run itrace via the I2C interface, use this option to specify the following: -d=DEVICE, where the device is an I2C device (such as mtusb-1) The default value is:/dev/mst/mt4099_pci_cr0. Specifies the name of the mst device driver for accessing the cr-space. Without the -w option, itrace will exit if there have been no new traces in the last 0.5 seconds. This is not the default behavior of itrace. Start the mst driver (mst start or mst restart).The mst driver must be started prior to running itrace tool. The desired trace mask is set (see the -m flag below).For adapters without on-board memory (MemFree): The RUN_FW command has been executed.For adapters with on-board memory: The SYS_ENABLE command has been executed.Debug firmware is burnt and loaded on the device.In order to print the firmware traces, the following are required: It prints trace messages in text format to the console. The utility is a command line application controlled by command line parameters. The trace buffer is located in host memory for MemFree adapter cards (i.e., without on-board memory), and in adapter memory for adapter cards with on-board memory. Trace messages generated by iRISCs are stored in the trace buffer. These trace messages inform developers of software drivers about internal status, events, critical errors, etc., for each iRISC. The itrace utility extracts and prints trace messages generated by the firmware of a ConnectX-2/ ConnectX-3/ConnectX-3 Pro adapter cards.
0 Comments
Read More
Leave a Reply. |